GYS AIRFIX DRAW ALIGNER Manual De Uso página 14

User manual
INSTALLATION AND INSPECTION CHECKS
REGULAR INSPECTION:
- Check that the screws are correctly tightened as described in the «assembly» section.
- Check that the foam gasket and pads are correctly positioned and undamaged.
- Check that the cord is correctly wound on the winch, and that it is not damaged.
If in doubt and/or if a defect is found, do not use the machine and contact the distributor or the manufacturer via the
After Sales Service.
INSTALLATION:
To ensure maximum adhesion to the floor, it is essential to position the Airfix Draw Aligner in a clean area (free of dust
liquids or other contaminants) with no cracks or joints between the tiles to ensure maximum vacuum performance.
The Airfix Draw Aligner is fitted with two rear wheels, tilt the column taking care not to damage the seal which is
located on the underside of the plate.
The Airfix Draw Aligner works with compressed air, the recommended pressure is between 5 and 8 bar.
USAGE:
- Move the pillar by tilting it backwards to the chosen work area.
- Position the Airfix Draw Aligner at an appropriate pulling distance, judged by the operator, as close as possible to the
point being repaired.
- Connect the compressed air hose. Check that the Airfix Draw Aligner is firmly anchored to the ground by pushing it
firmly.
14
Translation of the original
instructions
Screw the pulley to the bracket using two 19mm
spanners.
Fix the winch to its support using the reinforcement plate,
the support plate and the 3 bolts. Use a BTR H5 spanner.
Place the trolley with the winch on the column.
AIRFIX DRAW ALIGNER
Screw M12x85: 1
Washer M12: 2
Nut M12: 1
Screw M6x18 : 1
Screw M6x25 : 2
Nut M6 : 3