Beurer HT 80 Instrucciones Para El Uso página 18

General instructions for use
Step 1: Attaching/removing the brush attachment
> To attach a brush attachment to the hot air brush, place the re-
quired brush attachment on the hot air brush and carefully turn
it right and left until you see and hear it click in place.
> To remove a brush attachment from the hot air brush, hold
down the unlock button [1] on the brush attachment and pull
the attachment o the hot air brush.
> Allow the heated brush [3] and the curling brush [2] to cool be-
fore you remove them.
Step 2: Plugging the mains plug into the socket
> Insert the mains plug of the hot air brush into a suitable socket.
Step 3: Preparing your hair
> Dry your hair with a towel beforehand.
> Comb your hair thoroughly.
Only use the hot air brush on pre-dried, slightly damp and well-brushed hair.
Step 4: Blower and temperature settings
Slide the sliding switch [6] on the hot air brush to the required blower and temperature
setting (2, 1 or ).
Setting Blower and temperature settings
2 High blower setting, high tempera-
ture
1 Gentle blower setting, medium
temperature
High, cold blower setting
Step 5: After use:
> After use, slide the sliding switch [6] to position 0.
> Place the hot air brush on a heat-resistant surface and allow to cool.
> Then clean the hot air brush as described in chapter "7. Cleaning".
> Store the hot air brush in a safe, cool and dry place. If you prefer, you can hang up the
hot air brush using the hanging eyelet [10].
6. USAGE
Straightened hair
> Use the heated brush [3].
> If you have fi ne hair, slide the sliding switch [6] to position 1.
> If you have thick hair, slide the sliding switch [6] to position 2.
Hair type/application
For thick hair
For fi ne hair
For fi nishing the hairstyle
18