Titan FLEXSPRAY 0524085 Manual De Instrucciones página 7

Setup
IMPORTanT: Before connecting to the
power source, make sure that the power
cord voltage corresponds to the operating
voltage on the rating label. The unit must
be connected with a properly grounded
socket.
To set up:
1. Squeeze the side clips (a) together and
insert the air hose onto the turbine (b).
2. Unscrew the material container from the
front end assembly.
3. Align the suction tube:
a. If you are going to be spraying in an
upward direction, the angled end of the
suction tube should be pointing toward
the rear of the gun.
b. If you are going to be spraying in a
downward direction, the angled end
of the suction tube should be pointing
toward the front of the gun.
4. Pour in the prepared coating material
(maximum 1 quart).
5. Carefully screw the material container
back onto the front end assembly.
6. Connect front end and gun handle.
Plug in the power cord.
Turn the power switch on the top of the
turbine to ON.
The sprayer is now ready for
operation.
Notice:
Start
An English-language Quick Start guide label is
located on the turbine. French and Spanish versions
of this label are included with the unit. Either one of
these labels can be adhered directly over the English
label if English is not your preferred language.
1
b
a
3
a
a
5
7
2
4
b
1 Quart
b
6
English