Publicidad
Idiomas disponibles
Idiomas disponibles
Water and drain connections for Portable Model (GNW128P) using one faucet
connection only. (Continued)
NOTE: If you have Stationary Model (GNW128S) or Portable Model (GNW128P), and will use with two water valve
connections, then follow the connection instructions on the previous page and skip this one faucet connection section.
CONNECT TO WATER LINE
8
Remove the aerator from the sink faucet and screw on
the faucet adapter.
NOTE: Use pliers to unscrew the aerator from the sink
if it is too tight to unscrew by hand.
Attach the hose connector to the faucet adapter by
pulling down on the locking collar while lifting up on the
connector until it snaps into place. Make sure the water
filter provided is in place.
Pull down
CONNECT TO VALVE INLET
9
Unplug electrical cord before installing water hose. If not
installed, install rubber washer in one end of cold water
hose. Thread cold water hose onto BLUE connection
(left side).
NOTE: Only the cold valve will be connected for this
installation. Hot valve should NOT be connected.
Hand tighten and use pliers to tighten hoses between 1/8
and 1/4 turn beyond hand tight.
Attach to left
cold/blue
TIGHTEN CONNECTOR
10
Tighten
18
Installation Instructions
Faucet Adapter
Locking Collar
Lift up
and
lock on
Hose Connector
CONNECT DRAIN HOSE
11
Attach the drain connection side of the uni-couple hose
to the rear of the washer. Install the clamp on the drain
connection and tighten to prevent leakage of water.
Attach uni-couple hose
drain connection and clamp
(appearance will vary by model)
SET THE WASHER CONTROLS
12
Make sure that the Water Temp setting on the washer
control panel is set to Cold since only the cold inlet is
connected.
SLOWLY TURN ON THE WATER
13
FAUCET ALL THE WAY TO THE
DESIRED WASH TEMPERATURE
(appearance will vary by model)
49-3000284 Rev 2
Publicidad
