INVENTOR MP850S-BS Manual Del Propietário página 12

4.
Place the door on the desired
side making sure it is in its upright
position. Screw the top screws of the
door hinge. Slightly tilt, for better
positioning, and screw the bottom
hinge into place, and also screw the
removed foot on the other side. Once
completed, clip into place the plastic
hard cover.
Plastic Top Cover
As the top of the Mini Bar can be
removed, wall installation may be
applied, or for easy positioning
under a counter. Remove the
plastic cover from your device, and
select the most suitable placement
according to your needs.
12
5.
Check if door is aligned horizontally and
vertically and that the door when shut is
completely sealed from all sides. Finally
tighten the bottom hinge and re-adjust the
foot on the opposite side for correct leveling.
EN