Set Lamp; Set Communication Mode; Communication With Pc; Reading Data - Corby SFE0007 Manual De Instrucciones

SET LAMP

The LED lamp will automatically turn on when the safe door is opened. To dissable
or enable the LED lamp follow the procedure below;
(1) Connect CEU with safe using Micro USB Cable. After the CEU starts work, press
▼ or ▲ to choose 5.SetLamp, and press OK.
(2) Follow the above to reverse the setting.

SET COMMUNICATION MODE

(1) Connect CEU with safe using Micro USB Cable. After CEU turns on, press ▼ or
▲ to choose 7.CommMode, and press OK to enter into submenu.
(2) Choose the desired communication mode, and press OK (modes explained
below).
IO-A is for communication between the CEU and the safe.
IO-B is not used on this safe.
PC is for communication between the CEU and a computer.

COMMUNICATION WITH PC

IMPORTANT:
Digital Safe Software and Drivers must be
downloaded and installed from
https://www.corbyofwindsor.com/software/hotel-safe-softwar
e.zip for the CEU to be able to communicate with a PC.

READING DATA

(1) Go to https://www.corbyofwindsor.com/software/hotel-safe-software.zip
The hotel safe software will automatically begin downloading.
(2) The following warning may appear;
If so, click on the arrow and select Keep.
(3) Click on the download file to open.
0 5