Publicidad
BACK PANEL / RÜCKSEITE / PANNEAU ARRIÈRE / PANEL POSTERIOR / PANEL TYLNY / PANNELLO
POSTERIORE
MODE SELECTION / MODUS AUSWÄHLEN / SÉLECTION DE MODE / SELECCIÓN DEL MODO / WYBÓR
TRYBU / SELEZIONE DELLE MODALITÀ
EN
NOTE
When the projector is properly connected to the mains, the following information appears successively in the display during the startup process:
"Software Update, Please Wait..." (for service purposes only), the software version "Software V1.xx" and "WELCOME TO cameo". After this operation,
the projector is ready for use and changes back to the mode that was previously selected.
STATIC COLOUR
Press the "MODE" button to select the Static Colour Mode. "C000", then press the "ENTER" button to choose one of the static colours using the "UP"
and "DOWN" buttons (2. digit blinks). The "C1" represents Red, "C2" = Green, "C3" = Blue, "C4" = Amber and "CF" = strobe. Press ENTER (3. and 4.
digits blink) again to adjust brightness (C1, C2, C3, C4, 00-99) or strobe speed ( CF, 00-99) by using UP and DOWN buttons. Examples: If you set C1,
C2, C3 and C4 to zero, the Tri Par will have no LEDs on (blackout). If you set C1 to 99 and C2, C3 and C4 to zero, the Par will be 100% Red.
RED
00 - 99 beam brightness adjustable.
AMBER
00 - 99 beam brightness adjustable.
GREEN
00 - 99 beam brightness adjustable.
STROBE
00 - 99 speed adjustable.
BLUE
00 - 99 beam brightness adjustable.
13
Publicidad
