HomeMatic IP HmIP-WTH-B-2 Manual De Instalacion Y Uso página 34

Configuration menu
with the menu button.
• Select the desired hours using the
plus or minus button and confirm
with the menu button.
• Select the desired minutes using
the plus or minus button and con-
firm with the menu button.
To confirm, the time flashes twice and
the device changes back to the stan-
dard display.
7.6 Offset temperature
As the temperature is measured on the
room thermostat, the temperature dis-
tribution can vary throughout a room.
To adjust this, a temperature offset of
±3.5 °C can be set. If a nominal tempe-
rature of e.g. 20 °C is set but the room
presents with only 18 °C, an offset of
-2.0 °C needs to be set. An offset tem-
perature of 0.0° is set in the factory
settings. To adjust the offset tempera-
ture, please proceed as follows:
• Press and hold down the menu
button (E) to open the configurati-
on menu.
• Select "Offset" via the plus and mi-
nus buttons (D + F) in the menu.
• Confirm with the menu button.
• Select the desired offset tempera-
ture using the plus or minus button
and confirm with the menu button.
To confirm, the temperature flashes
twice and the device changes back to
the standard display.
7.7 Programming a heating profile
In this menu item, you can create a
heating profile with six heating and
cooling phases (13 change settings)
according to your personal needs:
• Press and hold down the menu
button (E) to open the configurati-
on menu.
• Select "Prg" using the plus or minus
buttons (D + F) and confirm with
the menu button.
• In the menu item "dAy", use the
plus and minus buttons to select
single days of the week, all week-
days, the weekend or the entire
week for your heating profile and
confirm with the menu button.
• Confirm the start time 00:00 pm
with the menu button.
• Select the desired temperature and
start time using the plus or minus
button and confirm with the menu
button.
• The next time is shown in the dis-
play. You can adjust the time via
the plus or minus buttons.
• Select the desired temperature for
the next time period using the plus
or minus button and confirm with
the menu button.
• Repeat this procedure until tem-
peratures are stored for the entire
period between 0:00 and 23:59 h.
To confirm, the time flashes twice and
the device changes back to the stan-
dard display.
34