Publicidad
Idiomas disponibles
Idiomas disponibles
VDV Wire Tester / English
4-3-2.Using the Tone Generator to Trace a Data Cable Cont
• The pins the tone is being sent through will be shown on the bottom of the display.
• Repeatedly press the Cycle
Button to select the desired pins.
• Refer to sequence chart below for explanation of pin selection.
Note: When tracing a cable run from the tone generator to the end of the cable, applying
the tone on a single pin will allow the tone to be detected at a greater distance from
the cable. When trying to locate a cable in an equipment room or patch panel, sending
the tone through all 8 pins or a single pair will limit the tone signal from spreading to
other nearby cables. The tone will be loudest when the probe tip is placed directly on
the wires the tone is being sent through at the end of the cable. When sending a tone
through a single pair, verification can be made by shorting the suspected pair. The tone
will be very faint when the pair the tone is being sent through is shorted.
12
4-3-3.Cable Identification on Installed Data Cable
• The remote ID's can be used to identify cable runs from the patch panel to a wall
port.
• Each identifier has a labeled ID number.
• When the tester is connected to a cable that has an identifier attached at the other
Tone Will Be Sent
end, the tester will display the ID number that is marked on the identifier.
Through Selected Pin
1. Connect the numbered remote ID's to the port for each cable that needs to be
Tone Will Be Sent
identified.
Through Selected Pair
2. At the wiring closet or patch panel, connect the unknown cable to the RJ45 port on
Tone Will Be Sent
the tester.
Through All 8 Pins
3. Press ON/OFF
select the data wire test function.
4. If the cable being tested is connected to one of the remote ID's,the display will
indicate the number that corresponds to the remote.
RJ45 Remote ID:
5 remotes
(Numbered 1- 5)
Note: The RJ45 remote ID's do not test the wiring on the cable. Only the remote can
identify wiring faults. The remote may not identify the cable if the cable is miss-wired.
VDV Wire Tester / English
Button to turn on the tester and then press Data
Wall Plate
3
Remote ID
Patch Panel
Button to
Tester
13
Publicidad
