Cleaning The Machine; Nuts And Bolts; Storage; Storing - ST BL 20 Li B Manual De Instrucciones

Phase Battery
(Fig.12)
1 A (right)
2 B (left)
3 A (right)
4 B (left)
NOTE Partial charge allows you to use the
machine to finish the job without waiting for a full
charge.
NOTE Don't remove the battery when the
machine is under charging.
NOTE Don't start the machine when it's under
charging status.

7.3 CLEANING THE MACHINE

• To reduce the risk of fire, keep the machine
free of leaves and twigs.
• Always clean the machine after use with a
damp cloth dipped in neutral detergent.
• Remove all traces of humidity using a soft
damp cloth. Humidity can generate risks of
electric shocks.
• Do not use aggressive detergents or solvents
to clean the plastic parts or hand grips.
• Do not spray water onto the motor and
electrical components and prevent them from
getting wet.
• Always keep the rotor clean and free of dust
and debris, by blowing compressed air through
the grille. Do not spray water on the rotor.
• To avoid overheating and damage to the motor
or the battery, always keep the cooling air
vents clean and free of debris.
7.4

NUTS AND BOLTS

• Keep all nuts, bolts and screws tight to be sure
the equipment is in safe working condition.
• Check regularly that the handles are fixed
firmly.
Charger
40%
40%
100%
When the machine is to be stored away:
1. Remove the batteries from their housing.
100%
2. Allow the engine to cool before storing in an
3. Clean (para. 7.3).
4. Make sure there are no loose or damaged
5. Store the machine:
6. The machine can be hung on the wall (Fig.14.
NOTE
minimum 20 kg
Charge the batteries (par. 7.2.2)
The batteries must be stored in closed and
humidity-free environments, at a temperature
between:
0°C - 60°C for 1 month
0°C - 45°C for 3 months
0°C- 25°C for 1 year
the battery every two months to prolong its
working life.
Whenever the machine is to be handled or
transported you must:
EN - 10

8. STORAGE

8.1 STORING

enclosed space.
components. If
damaged components and tighten any screws
and loose bolts or contact the authorised
service centre.
– in a dry place
– protected from inclement weather
– in a place where children cannot get to it
– making sure that keys or tools used
for maintenance are removed.
I - II).
Make sure that the wall can hold loads of

8.2 STORING THE BATTERY

NOTE If unused for any length of time, charge

9. HANDLING AND TRANSPORT

– Stop the machine (par. 6.5);
– Make sure that all moving parts have come
to a complete stop;
– Remove the battery from its housing and
charge it;
– Only take hold the machine using the
handgrips and position the pipes so that they
do not case obstruction.
– Make sure that machine movements do not
cause damage or injuries.
necessary, replace the