Publicidad
1
samsara.com/activate
Fleet
Alerts Settings Support
Please make sure to update the app to the
latest version before starting installation.
Make sure your Vehicle Gateway is
activated. This can be completed on the
Dashboard
or on the
Make sure the vehicle is in an area with reliable
cellular connection during installation.
3
Peel off the adhesive liner and firmly press the camera against the windshield for 30 seconds. Make sure there
are no large bubbles between adhesive and glass. Peel the protective film off the camera lens(es).
Note: If using the mount for angled windshield (ACC-CM-BSHIM), install it onto the camera before mounting to
the windshield.
4a
CM33 & CM34
Use the larger end (Hex M3) of the Allen key to
loosen both mount screws before adjusting. Rotate
the camera body so it hangs perfectly vertical, then
lightly tighten the screws. Do not fully tighten until
after the camera positioning is validated (Step 7).
For Front-Facing AI Dash Cam CM33, skip to Step 5.
For Dual-Facing AI Dash Cam CM34, go to Step 4b.
samsara.com/support
LTE
Armadillo Van Transport
>
Select Language
>
Install Devices
>
Send Feedback
>
Sign Out
installed
and
Samsara
Samsara Fleet
App.
Hex M3
© 2024 Samsara Inc.
2
Identify the mounting location on the windshield
and thoroughly clean with alcohol wipe. For optimal
visibility, the camera should be positioned below the
rear view mirror, within the windshield wiper sweep.
See mounting tips for
Allen key access on both sides of the device.
30s
4b
CM34
CM34 Only:
Use the smaller end (Hex M2) of the Allen key to
loosen the inward facing camera screw before
adjusting. Angle the lens towards the center of the
cabin. Do not fully tighten the screw until after the
camera positioning is validated (Step 7).
US
& UK. Ensure clearance for
Hex M2
3
Publicidad
