Publicidad
5
Run the cable across the top of the windshield.
Secure using cable clips or tuck the cable under
the glass seal around the windshield.
7
cloud.samsara.com
Turn the vehicle on. Confirm installation in either the Samsara Dashboard or the Fleet App:
Dashboard: On the vehicle page, go to Settings under the ... menu and click Take Picture.
Fleet App: Go to Install Devices under the ... menu, click Install new device, and follow the instructions for
CM33/34.
If all points of interest are not captured (see example frames above), use the provided Allen key to loosen the
cameras before re-adjusting. After all points of interest are captured, use the Allen keys to tighten both mount
locking screws and, if applicable, the inward camera locking screw. Do not overtighten.
Note: You may need to take a short trip for the camera to begin recording. A trip is registered when the Vehicle
Gateway reaches 5 mph (8 km/h).
For additional help, sign in to your Samsara account, click
samsara.com/support
Check Dash Cam Installation
Cancel
Settings
Request Support
Troubleshoot
© 2024 Samsara Inc.
6
Plug the camera into the Vehicle Gateway's USB
port. For best results, do not wrap the cable
around the Vehicle Gateway or route across the
diagnostics cable.
LTE
Take Picture
Calib rate Camer a
Help
Save
Take photo
Done
Take photo
Done
Get
Help, and
Contact Us
CM33
CM34
CM34
to submit a ticket.
4
Publicidad
