Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION! RISK OF EXPLOSION!
Never charge non-rechargeable
batteries!
Protect the rechargeable battery from heat,
for example from continuous exposure to
sunlight, fire, water and moisture. There is a
risk of explosion.
6. Service
a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained.
b) Never service damaged battery packs.
Service of battery packs should only be
performed by the manufacturer or authorized
service providers.
Safety instructions for all
applications
General safety instructions for grinding and
abrasive cutting
a) This power tool is designed to be used as a
grinder and abrasive cutting tool. Read all the
safety instructions, instructions, diagrams and
data that you receive with the tool. Failure to
follow all of the instructions below may result in
electric shock, fire, and/or serious injury.
b) This power tool is not suitable for sandpaper
sanding, working with a steel brush, polishing
or cutting holes. Using the power tool for
purposes for which it is not designed can lead
to hazards and injuries.
c) Do not use any accessories that have not been
specifically provided or recommended by the
manufacturer for this power tool. Just because
you can attach the accessories to your power
tool does not guarantee they are safe to use.
d) The maximum permissible speed of the acces-
sory tool being used must be at least as high
as the maximum speed specified for the
power tool. Accessories that rotate faster than
the permissible rate can break and throw pieces
into the air.
│
GB │ IE
■
6
e) The external diameter and thickness of the
accessory tool being used must comply with
the dimensions of your power tool. Incorrectly
dimensioned accessory tools cannot be suffi-
ciently shielded or controlled.
f) Accessory tools with a thread insert must
match the thread of the grinding spindle
exactly. For accessory tools that are mounted
using a flange, the diameter of the hole on
the attachment tool must correspond to the
width of the fitting on the flange. Accessory
tools that cannot be fitted precisely onto the
power tool will rotate unevenly, vibrate severely
and can lead to a loss of control.
g) Never use damaged accessory tools. Before
each use, check accessory tools such as
grinding discs for chips or cracks, grinding
plates for cracks, scuffs or excessive wear
and tear. If the power tool or the accessory
tool in use is dropped, check to see if it is
damaged or use an undamaged accessory
tool. When you have checked and inserted
the accessory tool, ensure that you and any
other people in the vicinity remain outside of
the range of the rotating accessory tool and
allow the tool to rotate at maximum speed for
one minute. Damaged accessory tools usually
break during this test period.
h) Wear personal protective equipment.
Depending on the application, ensure that
you use full face protection, eye protection or
safety goggles. If appropriate, use a dust
mask, ear protectors, protective gloves or
special apron to protect you from grindings
and material particles. The eyes should be
protected from flying debris that may be caused
during certain applications. Dust or filter masks
must be used to filter any dust produced by the
application. Long-term exposure to loud noise
can cause hearing loss.
i) Ensure that any bystanders are at a safe
distance from your work area. Anyone who
enters the workspace must wear personal
protective equipment.
Fragments of the workpiece or broken acces-
sory tools can fly off and cause injury – even
outside of the immediate working area.
PWSA 20-Li F4
Publicidad
