Descargar Imprimir esta página

Atosa YCF9401GR Manual Del Usuario página 28

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

2 - Use of the equipment
The refrigerator are for preserving fresh
perishable foodstuffs, with an in-built
EN
refrigerated unit.
The operating temperature for refrigeration is :
• between 0C and +8C at room temperature
of
+43C an 40%RD. The operating
temperature for frozen food maintenance is:
• between -17C and -22C at room temperature
of +43C an 40% RD.
3 - Technical features
The refrigerator is a ventilated system, the
evaporator is in a separate insulated box
on the top. All the materials used in the
manufacture of this unit are guaranteed
to be suitable for use with foodstuffs. The
gases used in refrigerator is R600a; in the
refrigerator for frozen food maintenance is
R290.
The refrigerating circuit are in compliance
with the current normative.
4 - Operation
The gas in the refrigerating circuit is in the
first time compressed, liquefied and then
evaporated in the ventilated evaporator,
situated on the top of the container.
heat from the the refrigerator compartment
using a refrigerant and removed to an
external location. The heat produced is then
dissipated to the outside environment by
a condenser unit located on the top of the
refrigerator.
5 - Control unit
unit The refrigerator is controlled by a «digital
control unit and a «main switch pilot light» in
the top panel of the refrigerator. The «main
switch pilot light» is for turning on and off the
power supply.
The green pilot light comes on to indicate
that the unit is connected to the main
electricity and to start work.
The green pilot light comes off to indicate
that the unit is disconnected and will not
work. The «digital control unit» is for the
regulaltion of all parameters to provide the
27
correct working of the refrigerator. Please
consult all parameters in the attachment
manual of the «digital control unit».
This manual is part of the instruction manual
and is very important in case of service.
6 - Handling
The refrigerator arrive in PET film and packed
in cardboard box on a wood pallet.
The refrigerator must be transported and
handled with care to avoid posing a hazard
to persons or property.
Never place a refrigerator with an in-built
refrigerated unit on its side or turn it upside
down as this may damage or impair operation
of the refrigerated unit. We can not held
liable for any damage or defects arising
directly or indirectly from improper handling
of the equipment or non-compliance with
the safeguards illustrated above.
7 - Installation procedure
• Place the refrigerator in the coolest and
best ventilated part of the room. Do not
install the refrigerator in near of heat and
direct sunlight sources.
• Remove the straps securing the cardboard
packing Remove the cardboard. Covering
• Remove the PET protection film
• Clean the refrigerator with mild detergent
and warm water and then dry with a soft
cloth.
8 - Connecting to the main power supply
This operation must be carried out by
professionally and qualified persons.
The refrigerator are supplied complete with
a power supply cable for the connection to
the main power supply. A thermomagnetic
circuit breaker (not supplied) must be installed
between the mains power point and the
power supply cable of the refrigerator.

Publicidad

loading

Este manual también es adecuado para:

Ycf9403grYcf9408grYcf9402grYcf9407grYcf9409gr