NOTE : the set value is stored even when the
procedure is exited by waiting the time-out to
expire.
Press «SET» to store the new value and move to
the following parameter.
To exit : Press
or
pressing a key.
NOTE: the set value is stored even when the
procedure is exited by waiting the time-out to expire.
5
. To lock the keyboard :
Keep pressed for more than 3s the
The «OFF » message will be displayed and the
keyboard will be locked. lf a key is pressed more
than 3s the «OFF » message will be displayed.
6. To unlock the keyboard :
Keep pressed together for more than 3s the
keys till the «on» message will be displayed.
LED
MODE
On
Flashing
On
Flashing
On
Flashing
On
°C
Flashing
On
°F
Flashing
Mess.
Cause
« P1 »
Room probe failure
« P2 »
Evaporator probe failure
« HA »
Maximum temperature alarm
«LA »
Minimum temperature alarm
« EA »
External alarm
« CA »
Serious external alarm
« dA »
Door open
Our products have been modified precisely
before leaving factory, so to avoid damaging
compressor unit or other malfunctions, users
mustn' t modify the microcomputer parameters
privately.
wait 15s without
OFFICIAL APPROVAL AND RULES
Our products full fill the present E.U. rules,
including the CE mark of the European official
approval
Machinery Directive (MD) 2006/42/EC
keys.
Electromagnetic Compatibility (EMC)
Directive 2014/30/EU
Serial Q C003-106-076
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product
SIGNIFACTION
should not be disposed with other household
wastes throughout the EU. To prevent possible
Compressor enabled
harm to the environment or human health
Anti short cycle delay
from uncontrolled waste disposal, recycle
enabled (AC parameter)
it responsibly to promote the sustainable
Defrost in progress
reuse of material resources.
Dripping in progress
To return your used device, please use
Fans output enabled
the return and collection systems or contact
the retailer where the product was purchased.
Fans delay after defrost
They can take this product for environmental
Measurement unit
safe recycling.
Programming mode
Measurement unit
Programming mode
Outputs
Compressor output according to « Cy » and « Cn »
Defrost end is timed
Outputs unchanged
Outputs unchanged
Outputs unchanged
All outputs OFF
Compressor and fans restarts
EN 60335-1
EN 55014-1
EN 60335-2-89
EN 62233
EN 61000-3-2
EN 61000-3-3
EN 55014-2
30