Truma CP classic Instrucciones De Montaje página 6

Installation instructions
Safety instructions
In-vehicle installations must comply with the
technical and administrative regulations of
the respective country of use (e.g. EN 1648,
VDE 0100-721). National regulations and
rules must be followed.
Observe the ESD regulations!
Scope of delivery
CP classic (for appliances without electrical heating elements)
1 CP classic control panel
1 Set of operating and installation instructions
CP E classic (for Combi Diesel E with electric heating elements)
1 CP classic control panel
1 CP E classic power selector switch
1 Control panel connecting cable
1 Set of operating and installation instructions
To be ordered separately
– Control panel cable (for connecting control panel / power
selector switch to the heater – available in different lengths)
– Cover frame, side parts and line-up clip if necessary
6
Assembly
Selecting a location
Install control panels in a location that is protected from moist-
ure and humidity.
CP classic control panel
– Drill hole with a diameter of 55 mm.
– Attention: Maximum control panel cable length 10 m.
– Attach plug (3) of the control panel cable (2) to the
control panel (1).
– Clamp the control panel cable (2) into the cable duct of the
control panel.
– Route the control panel cable (2) to the heater and plug it in.
– Make sure that all plugs are engaged.
– Secure the control panel with 4 screws (4).
– Fit cover frame (10) with side parts (11).
m
5 5
Ø
2
3
m
4
3
1
11
10
11