[Handlebar Handle Kit Models] Installing Debris Shield; Installing Trimmer Head - Maruyama B23L Manual Del Propietário

232025-04 12.11.30 11:49 AM ページ 15
[Handlebar Handle Kit Models]
Installing Debris Shield
POTENTIAL HAZARD
• For eign objects can be thr own by
Brushcutter.
WHAT CAN HAPPEN
• Contact with thrown objects can cause
personal injur y.
HOW TO AVOID THE HAZARD
• Never operate the Brushcutter without
the debris shield in place.
1. Exchange the M5 x 12 screw for with use the
debris shield as shown.
2. Attach the debris shield to the shaft with the two
M5 x 30 screws and plate as shown.
M5 x 30
M5 x 12 Screw Screw (2)
Gearcase

Installing Trimmer Head

IMPORTANT: The boss adapter must be,
installed on the attaching shaft between the
gearcase and the trimmer head as shown. And
Trimmer head adapter is left-hand thread.
Gearcase
3 mm Hex Wrench
Trimmer Head
232025-10.indd 14
WARNING
Debris shield
Plate
Attaching Shaft
Boss Adapter
Trimmer Head Adapter
1. Install the boss adapter onto the attaching shaft
out of the gearcase.
2. Align the hole in the boss adapter with the hole in
the gearcase.
3. Insert the 3 mm hex wrench into the holes in the
boss adapter and gearcase to lock the attaching
shaft.
4. Thread the trimmer head adapter into the attaching
shaft, then tighten the trimmer head firmly by
hand.
POTENTIAL HAZARD
• If the trimmer head is not adequately
tightened, it can come loose from the
Trimmer during use.
WHAT CAN HAPPEN
• This may cause damage to property or
personal injur y.
HOW TO AVOID THE HAZARD
• Make sure the trimmer head is securely
fastened to the attaching shaft in the
gearcase.
— US-14 —
WARNING
13/12/25 14:51