PARTS WASHER
EN
Specifications:
Overall dimensions: 1125x520x880mm
Tank dimensions: 1098x520x270mm
Max solvent capacity: 150L (40Gallons)
Pump output through hose: 50gph
Electrical requirements:220v/50Hz/0.5A
Gross weight: 45kg
1. Remove machine from carton and inspect for any visual damage.
2. Remove parts inside the machine.
3. Lay clean cardboard on floor and lay machine on its lid. (Make sure you hold cover
closed when laying machine on its lid.)
4. Mount four legs on brackets with m6x12 Philips head screws and m6 keps nuts.
Note:do not tighten.
5. Place lower shelf between legs with flat surface down and attach to legs with m6x12
Philips head screws and m6 keps nuts.
6. With legs pressed tight against lower shelf, tighten all screws to lower shelf.
7. Tighten all screws installed in step 4.
8. Stand machine up; be careful to hold lid closed.
9. Place work shelf and basket into the machine.
10. Mount pump assembly into slot on the side of the machine. Place filter screen in
position.
11. Plug machine into standard 220 volt 50 hz grounded outlet and fill with proper amount of
fluid.
12. Turn switch on fluid should not be flowing from the flexible spigot.
ASSEMBLY INSTRUCTIONS