Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Safety instructions
GB
MT
Malfunction causes and remedies
Defect
Appliance does
not switch on.
UV Gel s does not
harden suffi ciently.
After hardening,
a "sweat layer" re-
mains on the nails.
The artifi cial nails
are soft/loosened.
The artifi cial
fi ngernails show
unevenness.
A UV lamp does
not glow.
114
In this chapter you will receive important information for malfunction localization
and remedies. Observe the instructions in order to avoid risks and damage.
WARNING
Observe the following safety information to avoid risks and property damage:
►
Repairs to electronic appliances may only be carried out by specialists who
have been trained by the manufacturer. Considerable risk to the consumer
and damage to the appliance can occur as a result of incompetent repairs.
The following table will help with localizing and remedying minor malfunctions:
Possible cause
The plug is not connected.
Mains power socket does
not supply any voltage.
The selected treatment
time too short.
One or more UV lamps
are defective.
Too much UV-Gel s applied.
The nails were not directly
under the UV lamps.
Occurence of a "sweat-
layer" caused by polyme-
rization.
Loosening of the artifi cial
nails by products with a
high acetone concentra-
tion.
Pressure on the brush e
too high when applying
the UV Gel s.
UV Gel s unevenly applied.
UV lamp defect.
Solution
Insert the plug into the mains
power socket.
Check the fuses.
Select a longer treatment time.
In this case, contact Customer
Services.
Apply less UV Gel s.
Hold the hand correctly in the
UV appliance 1.
Remove the "sweat layer" with
the fi nishing solution p.
Apply no products with a high
acetone concentration.
Do not press too hard on the brush
e when you are applying the UV
Gel s.
Apply a further and thinner layer
of UV Gel s and then harden it.
Replace the defective UV lamp.
SNS 45 A2
Publicidad
