Getac X600 Guia De Funcionamiento página 3

Getting Started
NOTE: The information in this document applies
to both X600 and X600 Pro models though most
illustrations show the X600 model as the example.
Unpacking
Notebook computer Main battery pack × 2
Document(s)
AC adapter
Additional battery
pack (for X600 Pro)
–or–
AC power cord Stylus and tether*
* Optional
Installing the Battery Packs
Main Battery Packs
The computer has two battery compartments
( and ) for two battery packs; each is
installed in the same way.
1. Slide the protective cover toward the
unlocked position. Then, flip open the cover.
( as the example)
2. Noting the orientation, insert the battery
pack all the way into the compartment.
3. Use the ribbon strip to pull the battery's
locking latch toward the locked position
( ). The latch should click into place.
4. Close the cover and slide it toward the locked
position.
CAUTION: Make sure the cover is correctly locked,
not revealing the underneath red part.
Additional Battery Pack
X600 Pro models come with an additional battery
pack to be installed in the expansion unit.
The installation method is similar to that for the
main battery pack. The only difference is that
there are two ribbon strips. After the battery
pack is inserted, pull the left strip toward the
left and the right strip toward the right so that
the two latches click into the locked position.
NOTE: The additional battery pack alone
cannot be the power source for starting up the
computer.
Connecting to AC Power and
Starting Up
The first time you use your computer, connect
the AC adapter.
1. Connect the AC adapter as shown below.
NOTE: The power cord type varies with countries.
2. Open the top cover by pulling the cover latch
and lifting up the cover.
3. Press the power button (
4. The Windows operating system should start.
When turning on your computer for the very
first time, you will be guided through a setup
process. Follow the onscreen instructions to
complete.
) to start up.
1