GreenWorks G24X2LM41K4X Manual Del Operario página 7

1 DESCRIPTION
1.1 PURPOSE
This machine is used for domestic lawn mowing. The cutting
blade must be approximately parallel to the ground. All four
wheels must touch the ground while you mow.
1.2 OVERVIEW
Figure 1~9
Bail switch
1
Start button
2
Upper handle
3
Lower handle
4
Rear discharge flap
5
Battery compartment flap
6
Grass catcher
7
Mulch plug
8
Quick-release lever
9
Cam lock
10
Knob
11
Hook
12
Slot
13
Battery pack
14
Safety key
15
Battery release button
16
Height adjustment button
17
Nut
18
Spacer
19
Blade
20
2 SAFETY
WARNING
Make sure that you follow all safety instructions.
Refer to Safety Manual.
3 INSTALLATION
WARNING
Do not use accessories that are not recommended by the
manufacturer.
WARNING
Do not put in the safety key or the battery pack until you
finalised the assembly of all the parts.
English
3.1 UNPACK THE MACHINE
Make sure that you correctly assemble the machine before
use.
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
3.2 UNFOLD AND ADJUST THE
LOWER HANDLE
Figure 2.
1. Pull up and back the upper handle to lift the handle into
operation position. Make sure that the handles click into
position correctly.
2. Tighten the lower handle with the quick-release levers on
the two sides.
Make sure that the two handles are in the same position.
Do not make damage to the cables when you fold or unfold
the handle.
3.3 INSTALL THE UPPER HANDLE
Figure 3
1. Align the holes in the upper handle and the lower handle.
2. Put the cam locks through the holes.
3. Tighten the knobs onto the cam locks.
4. Do the same operation on the other side.
3.4 INSTALL THE GRASS CATCHER
Figure 4
1. Remove the mulch plug.
2. Open the rear discharge flap and hold it.
3. Hold the the grass catcher by its handle and put the hooks
over the slots.
5
WARNING
WARNING
NOTE
WARNING
EN