Enjoying Dolby Pro Logic Surround Effects - Sony MHC-G99AV Manual De Instrucciones

rear panel
video
equipment
Connect With
AUDIO OUT jacks of VIDEO/MD IN
the video equipment jacks
Press FUNCTION repeatedly until
"VIDEO" appears in the display.
The video equipment sound comes through
the speakers. You can also record the video
equipment sound.
When Connecting More
Than Two Video Units at
the Same Time
Use an audio/video connecting cable and
make sure to connect the plugs to jacks of
the same color.
rear panel
VCR etc.
a TV
LD player
etc.
Connect video equipment to the TV. For
more details concerning the connections,
refer to the operation manuals of the video
and the TV.
Connect With
AUDIO OUT jacks of VIDEO/MD IN
the video equipment jacks
Select the input source of the desired VCR
on the TV. Then press FUNCTION
repeatedly until "VIDEO" appears in the
display.
The video equipment sound comes through
the speakers. You can also record the video
equipment sound.
Enjoying Dolby Pro
Logic Surround
Effects
To make the Dolby Pro Logic Surround
effects work, you need to use video tapes or
Laser discs etc. that carry the Dolby
"q" or "A" logo.
Adjusting the sound level
of speakers
To enjoy Dolby Pro Logic Surround effects,
adjust the volume levels of the front, center
and rear speakers by using the test tone.
POWER n ON
1
4,6
1
Press and hold down DOLBY PRO
LOGIC for more than a second.
2
Turn the JOG dial to choose the Dolby
Pro Logic Surround mode you want.
The display changes as follows:
NORMAL
For details on each mode, see "Dolby
Pro Logic Surround Modes" of this
chapter.
3
Turn VOLUME (or press VOLUME
(+/–) on the remote) so that the volume
for the front speakers is set to your
normal listening volume.
4
Press T. TONE ON/OFF on the remote.
The test tone is automatically output
from each speaker in the sequence
shown below.
NORMAL mode
Front left
Center
Front right
Rear
PHANTOM mode
Front
Rear
3
3CH LOGIC mode
2
Front left
Center
Front right
5
While sitting in your normal listening
position, adjust the volume using
CENTER LEVEL +/– and REAR LEVEL
+/– on the remote so that the volume
5
level of each speaker is at the same level.
3
(When you turn VOLUME on the unit,
the volume changes for all speakers.)
6
After you have finished making all
adjustments, press T. TONE ON/OFF to
shut off the test tone.
continue to next page
Chapter 6: Dolby Pro Logic Surround
PHANTOM
3CH LOGIC
EN
23