DO324A
5. MODE- touch
With this touch you can select the desired function. Every time when pressing this
touch the function will change : AUTO – COOL – DRY – FAN. The related indication
light will turn on on the control panel.
6. TIMER touch
With this function you can select when the unit must turn on or off.
7. SWING touch
To adjust the air direction.
8. LED display
Will show het temperature and timer selections. When the "dry or "fan" mode is se-
lected, the display will show the room temperature.
Power management feature
9.
When the ambient temperature is lower than the set temperature, the appliance
will automatically switch to the power management mode. The compressor and
fan will stop working and the indicator light of the power management mode
will light up. When the ambient temperature rises above the set temperature,
the appliance will automatically leave the power management mode and the
light will go off again. The compressor and (/or) fan will start operating again.
ERROR CODES
Following error codes can be displayed on your airco :
-
E1 : the sensor for the room temperature is not working. Turn off the unit and
remove the plug from the socket. Wait for 10 sec and plug the unit back in.
Turn on the unit. When the error codes repeats, you need to contact the after
sales service.
-
E2 : The sensor of the dehumidifier doesn't work. Turn off the unit and re-
move the plug from the socket. Wait for 10 sec and plug the unit back in.
Turn on the unit. When the error codes repeats, you need to contact the after
sales service.
-
E4 : The display is not functioning properly. Remove the plug from the sock-
et. Wait for 10 seconds. Plug the unit back in. When the error codes repeats,
you need to contact the after sales service.
-
P1 : The water tank is full. Connect the drain hose to the bottom drain and
remove the water. When the error codes repeats, you need to contact the after
sales service.
1. COOL function
INSTRUCTIONS OF USE
Press the "mode" touch until the "cool" indication light turns on.
64