Publicidad
Idiomas disponibles
Idiomas disponibles
-
Place the wall adaptor in the opening.
-
Place the round ring on the air outlet hose.
-
Place hose with the round ring on the wall adaptor.
NOTE : Make sure the air outlet hose isn't bend during use.
Make sure there is a free surrounding of at least 50 cm around the outlet.
DRAINING
During the "dry" mode you can use a permanent drainage.
-
Remove the permanent drain plug.
-
Attache the drain hose on the permanent drain.
-
Make sure the water is drained in a save and permanent way.
When you don't use the permanent drain, the non recycled condesation
water, will be stored in the water tank.
-
When the water tank is full a few beep signals will be heard and
on the display the code P1 will appear. The "cool" or "dry" mode
will end automatically. The fan will continue to operate, this is
normal.
-
Move the unit over to a place where you can easily drain the
water.
-
Remove the drain plug at the bottom of your unit and drain the
water.
-
After fully draining the water tank, place the drain plug back on
the drain opening.
-
Restart the unit, make sure the error code P1 is no longer displayed. When
the code doesn't disappear, try turning off and on the unit a few times. When
the error code continues, please contact the after sales service.
NOTE : always make sure to install the drain plug, before turning the unit back
on.
CLEANING AND MAINTENANCE
Important :
-
Always remove the plug from the socket before
cleaning the unit.
-
Never use any chemical or abrasive products to
clean the unit.
-
Never clean the unit with water or any other liquid,
this can cause electrocution.
-
When the power cord is damaged it must be re-
paired or replaced by the after sales surface of the
manufacturer or by a qualified person.
67
DO324A
1
2
Publicidad
