Publicidad
Idiomas disponibles
Idiomas disponibles
HOW FUMEREX WORKS: TEST PROCEDURE
C
The TEST button intended for verification if the unit is operational as well as to switch it to Wake-
UP mode and send an informational SMS text message identified as the Test SMS, which provides
the following:
•
GSM signal strength
•
Barrery level
Test your detectors weekly and upon returning from vacation or when no one has been in the
household for several days. DO NOT use an open flame to test the device. You may ignite and
damage the unit or your home.
To perform the test, please follow the instructions:
•
Firmly push the TEST button for two seconds and the detector will sound a loud beep. The
alarm will stop sounding after releasing the TEST button.
•
Stand at arm's length from the detector when testing.
In the event of test, the system will follow this pattern:
•
The system switches to Wake-Up mode (see SLEEP AND WAKE-UP MODES).
•
When the system is successfully registered with the GSM network, a red indicator on the front
panel begins to flash approximately twice per second. This indicator is flashing all the time, when
the system is ready to send SMS text messages, accept the SMS text messages and phone calls.
•
The system attempts to send an SMS text message regarding test event to all listed user phone
numbers simultaneously.
•
If the TEST button has been pressed repeatedly while the Wake-Up mode period is in progress, the
Wake-Up mode period will be extended.
•
The system may fail to deliver the SMS text message to the listed user phone number due to the
following reasons:
•
system or user's phone has been out of GSM signal coverage.
•
user's mobile phone has been switched off.
•
The system sends the SMS text message only once and in case of all unsuccessful attempts within
a Wake-Up period, the system will switch to Sleep mode and erase the alarm event from the
memory.
•
Sensors tests result
EN
13
Publicidad
