Emerio CH-106492.4 Manual De Instrucciones página 4

23. The heater must not be located immediately below a socket outlet.
24. Do not insert any object through the heat outlet or air intake grilles of the heater.
25. Do not use the heater in areas where flammable liquids are stored or where flammable fumes may be
present.
26. Particular care should be taken when the heater is situated in areas occupied by children or disabled
persons.
27. Always unplug the heater when moving it from one location to another.
28. Do not use the heater if the power cord is damaged.
29. Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
30. WARNING: In order to avoid overheating, do not cover the heater.
31. The appliance should not be operated by means of an external timer-switch or by means of a separate
system with remote control not originally belonging to this appliance.
32. This heating device is not suitable for assembling in vehicles and machines.
33. Means "DO NOT COVER".
PARTS DESCRIPTION
1. Air outlet
2. Power switch (750W; 1250W; 2000W)
3. Thermostat
4. Air inlet
5. Feet
OPERATION OF THE HEATER
Note: When the heater is turned on for the first time, or when it is turned on after a longer period of storage,
it is normal that the heater may emit some smell and fumes. This will disappear when the heater has been on
a short while.
Set the thermostat to the minimal position and insert the plug to the power supply.
⚫
Turn on the power switch: low heating = 750W; medium heating = 1250W, high heating = 2000W (Both
⚫
switches are on). When the power switch is on, the indicator light on the switch will illuminate.
Turn the thermostat knob in a clockwise direction to the max position.
⚫
Once the room temperature has reached the desired value, turn the thermostat knob slowly in
⚫
anti-clockwise direction until you hear a "click" sound; this is the setting temperature.
The appliance will automatically maintain the setting temperature. It will switch on when the room
⚫
temperature is below the setting, and switch off if it is above the setting.
Caution: The heater will remain hot for some time after it is turned off. Handle with care.
OVERHEAT PROTECTION
This heater is protected with an overheat protection that switches off the appliance automatically in case of
overheat, e.g. due to the total or partial obstruction of the grids. In this case, unplug the appliance, wait
about 30 minutes for it to cool and remove the object which is obstructing the grids. Then switch it back on
as described above. The appliance should operate normally. Should the problem persist, please contact the
nearest customer service.
- 3 -