STEAMONE STEAMCUBE Guia De Inicio Rapido página 10

Tank
Always fill the tank with half demineralized water.
Water level indicator
Lights up when the tank is empty.
Fill the tank to the top.
ON/OFF
Turn the knob to the right to turn on; left to turn off.
Indicator light
Lights up when the steamer is on.
Medium mode - default (cotton, wool)
The indicator light will flash for 2 min. When the LED
lamp stops flashing, the steamer is ready for use.
Switching to another mode takes a few seconds (the
LED lamp flashes, then stops flashing).
Eco mode (silk, light fabrics)
Appuyer une fois pour activer le mode de puissance Éco.
A/ Le mode Max (jean, lin)
Press the button once to activate the Max power
mode.
B/ Dry-cleaning mode (very thick fabrics)
To be used only for horizontal ironing. Press and hold
the button for 3 sec to activate this mode. Once it is
activated, the LED lamp flashes quickly.
Warning : The Dry-cleaning mode has a very powerful
steam flow. Use it carefully to avoid burns.
A small quantity of water may be present under the unit, but
this is normal. This is due to the process of decompression of
the tank, releasing pressure from the bottom of the unit. All
high-pressure devices include a safety device that triggers when a
certain accumulated pressure is exceeded.
Steam activation
Steam output control button :
press the button to control its output.
Warning: A 5s pause is triggered every 15s of
continuous steam, for cooling.
English
Drain indicator
To make sure that the steamer remains covered by the
warranty, drain the device to remove limescale from the
heating system.
As soon as the white indicator light lights up, the
steamer must be drained. The steam is no longer
available until the draining is carried out.
Draining procedure
How to proceed:
- Wait until the steamer cools down (minimum 2h after
use), then unplug it;
- Unscrew and remove the yellow plug (located
under the steamer) to empty the limescale inside the
steamer. This should be done over a container;
- After emptying, screw the knob back on tightly to
avoid leaks. Turn the steamer back on and press the
maintenance button (9) for 2 sec to reset it.
Procedure for resetting the maintenance button (9)
when it flashes: After draining the device, turn on the
product and IMMEDIATELY press the maintenance
button (9) and hold for 5 seconds (until the LED turns
off).
Be careful if the boiler has already filled with water,
drain again and reset the maintenance button
immediately when turning on the device.
Spray head - maintenance
When the steamer is cooled down and unplugged, fill
a container with white vinegar. Soak only the metal
surface of the head for 1h, then rinse with fresh water
and a soft cloth.
Use the cleaning brush to remove limescale deposits
from the steam vents.
Warning: If water leaks into the steam head, please
perform the draining procedure.
If you have any problems with the product, please visit www.steam-one.com or
contact our service department at info@steam-one.com
03