Aqua Medic DrainTuna Manual De Instrucciones página 7

Red LED in the centre (Fig. 1, No. 3): Lower float S2 up = water level o.k.
-
Red LED on the right (Fig. 1, No. 4): Both floats up = water level too high.
-
The DrainTuna reduces the pump output to the set value - 8%. If this is not sufficient, open the easy drain
or tap further and/or reduce the pump output.
4. Operation with DC Runners of the x.2 series:
When using DC Runners from the x.2 series, the pump output is not displayed as a percentage in the controller.
Proceed as follows:
Point 3 is different from the pumps of the x.3 series. Points 1, 2 and 3 correspond to the
specifications under 3.1, 3.2 and 3.4 for the x.3 series.
1. Hang the float holder in the shaft. The marking should be at the height of the desired water level (Fig. 3).
2. Connect the float and the power supply unit (Fig. 1), connect 0 - 10 V cable. (0 - 10 V socket on the side of
the x.2 controller).
3. Activate 0 - 10 V control on the x.2 controller: Press and hold the FEED button until 4 LEDs light
up. Set the pump output to the desired maximum output using the rotary knob on the DrainTuna.
Maximum power: Turn the rotary knob all the way to the right.
Minimum power: Do not turn the rotary knob all the way to the left, as the pumps in the x.2 series
no longer start reliably at power levels below 50%. (Attention: Exact power display not possible!).
4. Adjust the drain tap so that the water level slowly reaches the marking (Fig. 3, no. 3).
Available spare parts: Please refer to www.aqua-medic.de.
5. Warranty conditions
AB Aqua Medic GmbH grants the first-time user a 24-month guarantee from the date of purchase on all material
and manufacturing defects of the device. Incidentally, the consumer has legal rights; these are not limited by
this warranty. This warranty does not cover consumable parts, due to normal wear & tear ie: pre-filter or
membrane etc. The original invoice or receipt is required as proof of purchase. During the warranty period, we
will repair the product for free by installing new or renewed parts. This warranty only covers material and
processing faults that occur when used as intended. It does not apply to damage caused by transport, improper
handling, incorrect installation, negligence, interference or repairs made by unauthorized persons. In case of
a fault with the unit during or after the warranty period, please contact your dealer. All further steps
are clarified between the dealer and AB Aqua Medic. All complaints and returns that are not sent to
us via specialist dealers cannot be processed. AB Aqua Medic is not liable for consequential damages
resulting from the use of any of our products.
AB Aqua Medic GmbH - Gewerbepark 24 - 49143 Bissendorf/Germany
- Technical changes reserved – 03/2024/v1
7