Mitsubishi Electric Mr. SLIM SLZ-M FA Serie Manual De Instalación página 14

7. Electrical work
Service menu
Test run
Input maintenance info.
Settings
Check
Others
Main menu:
Cursor
F1 F2 F3 F4
Fig. 7-7
Function setting
Ref. address
en
Unit No.
Grp./1/2/3/4/All
Monitor:
Cursor Address
F1 F2 F3 F4
Fig. 7-9
Function setting
Ref. address Grp. (1/8)
Mode 1 1
2
Mode 2
1
Mode 3
Mode 4 1
Request:
Value
F1 F2 F3 F4
Fig. 7-11
12
Settings menu
Function setting
Rotation setting
Service menu:
Cursor
F1 F2 F3 F4
Fig. 7-8
Function setting
Ref. address Grp. (1/8)
Mode 1 1
Mode 2 2
Mode 3 1
1
Mode 4
Save:
Cursor Page
F1 F2 F3 F4
Fig. 7-10
Function setting
Ref. address Grp.
Sending data
F1 F2 F3 F4
Fig. 7-12
7.3. Function setting
7.3.1. For wireless remote controller
Refer to the installation manual included with the wireless remote controller.
7.3.2. Function setting on the unit (Selecting the unit functions)
1 (Fig. 7-7)
• Select "Service" from the Main menu, and press the [SELECT] button.
• Select "Settings" from the Service menu, and press the [SELECT] button.
2 (Fig. 7-8)
• Select "Function settings" with the [SELECT] button.
3 (Fig. 7-9)
• Set the indoor unit refrigerant addresses and unit numbers with the [F1]
through [F4] buttons, and then press the [SELECT] button to confirm the
current setting.
<Checking the Indoor unit No.>
When the [SELECT] button is pressed, the target indoor unit will start fan
operation. If the unit is common or when running all units, all indoor units for the
selected refrigerant address will start fan operation.
4 (Fig. 7-10)
• Toggle through the pages with the [F3] or [F4] button.
• Select the mode number with the [F1] or [F2] button, and then press the
[SELECT] button.
5 (Fig. 7-11)
• Select the setting number with the [F1] or [F2] button.
Setting range for modes 1 through 28: 1 through 3.
Setting range for modes 31 through 66: 1 through 15.
6 (Fig. 7-12)
• When the settings are completed, press the [SELECT] button to send the set-
ting data from the remote controller to the indoor units.
• When the transmission is successfully completed, the screen will return to the
Function setting screen.