Crosby IP IPBK10 Manual De Usuario página 6

Idiomas disponibles

On the inside of the front cover illustrations have been included of damaged and worn (rejected)

pivots and camsegments:

1. One complete tooth not sharp and one damaged

2. Two teeth damaged for 50%

3. One tooth damaged for 100% and one tooth damaged for 50%

4. Two rings damaged for 100%

5. Interior ring damaged for 100%

These areas of damage, precisely as wear, are not covered by the warranty.

In most cases however the areas of damage are much less extensive. In doubtful cases an author-

ised repairer should assess the clamp.

How to operate the clamp

The IPBK lifting clamps are suitable for the lifting, stacking and transport of steel beams and profiles

of which the web must be kept in a horizontal position.

See illustrations 3 - 6 for part reference.

1. Open the clamp by pulling the latch lever (A) into the direction of the arrow (3).

2. Place the clamp on the beam and exercise pressure, so that the jaw of the clamp as far as

possible over flange of the beam (4).

3. Pull the latch lever (A) towards the lifting eye (D). The clamp will now close and will remain on

the plate in pretensioned position, allowing lifting to commence (4).

4. As soon as the load is at its destination let the crane hook descend until the clamp is fully free

of load, meaning that the lifting chain is no longer taut and the lifting eye (D) of the clamp can

move freely. To release the load pull the latch lever (A) towards the jaw, allowing the clamp to

be and remain opened (5).

5. The clamp may now be used again immediately or put away in opened position. This position

will protect the teeth from damage (6).

A reliable clamp, a secure basis for lifting

10 Year warranty preventive maintenance procedure:

During every maintenance service the most critical parts, being pivot(s), camsegment and spring

are replaced and, when necessary, any rejected parts will be replaced.

10 Year warranty repair procedure:

During every repair service the most critical parts, being pivot(s), camsegment, spring, shafts and

latch lever will be replaced and, when necessary, any rejected parts will be replaced.

Please consult www.thecrosbygroup.com/resources/crosbyip-10-year-guarantee for more infor-

mation on maintenance procedures.

Maintenance without 10 year warranty: Annually clamps are subjected to inspection* and parts will

be replaced only when they no longer meet our standards.

*CrosbyIP authorised repairer

Ipbkz