Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Use a 6 mm socket and wrench or 6 mm nut driver to
remove the LP brass orifice from the end of gas valve. The
main burner NG orifice is located behind the LP orifice, so
no additional orifice needs to be installed.
5.
Reinsert the burner and reattach using the cotter clip and
screws previously removed. Repeat the procedure for
each main burner.
6.
Position the igniters so they are 3.2 mm / 1/8 in away from
each burner.
Change The Rear Burner Orifice
1.
Use a screwdriver to remove the two screws from the rear
burner heat shield. Remove the heat shield.
2.
Unscrew from the rear burner cover and remove the sear
burner rear cover.
3.
Use an adjustable wrench to remove the brass elbow.
4.
Use a 6 mm socket wrench or 6 mm nut driver to remove
the orifice. Replace with the corresponding natural gas
orifice.
IMPORTANT: Check that the NG orifice is properly
installed inside the valve.
17
Publicidad
