Publicidad
Idiomas disponibles
Idiomas disponibles
GRILL LIGHTING INSTRUCTION
VERY IMPORTANT: ALWAYS INSPECT THE HOSE PRIOR TO EACH USE.
BEFORE LIGHTING:
Inspect the gas supply hose before turning the gas "ON". If there is evidence
of cuts, wear, or abrasion, it must be replaced before use. The replacement hose
assembly must be that specified by the manufacturer.
VERY IMPORTANT: TO LIGHT MAIN AND SIDE BURNERS OF THE GRILL:
1) Read instructions before lighting.
2) Turn all knobs to "OFF" then open the LP tank valve. Always keep your face
and body as far from the grill as possible when lighting.
3) Open lid during lighting.
4) Push and turn any control knob slowly to "HI" position. The built-in igniter will
click and spark simultaneously to light the pilot and burner in sequence.Turn
the control knob to "OFF" IMMEDIATELY if the burner does not light within 5
seconds. Wait 5 minutes for gas to dispel, then repeat the lighting procedure.
5) Follow match lighting instructions if burner can't be lit after repeating 3-4 times.
TO LIGHT THE MAIN AND SIDE BURNERS BY MATCH: (AS THE
FOLLOWING FIGURE SHOWS)
If the burner will not light after several attempts then the burner can be match lit.
Tools: Lighting rod (hanging behind the right door)
Usage:
1) Read instructions before lighting.
2) Open the lid during lighting.
3) Simply place a lighted match between the coils on the end of the lighting
rod and hold next to the burner to ignite.
4) Push and turn the knob to "HI" position, make sure the burner lights
and stays lighted.
5) Repeat 3-4 to light other burners.
6) Keep a spray bottle of soapy water near the gas supply valve and
check the connections before each use. Do not light the grill if odor
of gas is present, call our service center.
19
Publicidad
