Publicidad
Idiomas disponibles
Idiomas disponibles
NEVER LEAVE HEATER UNATTENDED WHILE CONNECTED TO A POWER SOURCE
Operation
1.
Position the heater so that it stands
upright on a firm, level surface and at a
safe distance from wet environments and
flammable objects.
2.
Connect the fan heater to the proper
electrical power.
3.
Set the Thermostat Control Dial to the
highest setting by turning the knob all the
way to the right.
4.
The heater will switch on when the
function selector dial is set to one of the
three power settings.
Setting
Unit is Off
Fan Runs - No heating
Fan Runs - Low Heat
Fan Runs - High Heat
5.
When using the heater for the first time,
you may notice a slight emission of smoke.
This is normal and will stop after a short
time. The heating element was coated with
a layer of protective oil during production.
The smoke is caused by the leftover oil as
it is heated.
Automatic Overheat Safety Control
–
This heater is equipped with safety internal
heat limiting thermostat and overheat
protection circuit. When a potential
overheat temperature is reached, the system
will automatically shut the heater off.
© 2023 Pinnacle Climate Technologies, Inc.
Operation
Function
Thermostat Instructions
–
Set the thermostat to the highest setting
and let the heater operate with full power
input. When the room temperature reaches
the required value, turn the thermostat to
the left until it switches off.
–
The thermostat will then switch on and
off automatically to control the room
temperature according to the preset value
and keep the room temperature constant.
Cleaning and Maintenance
–
Before cleaning the appliance, disconnect it
from the outlet and let it cool down.
–
The enclosure is easy to get dirty. Wipe
it often with a soft sponge. For very dirty
parts, wipe with a sponge dipped in <
122°F water and mild detergent, then dry
the heater enclosure with a clean cloth. Be
careful not to let the water enter the inside
of the appliance
–
In order to protect the enclosure, do not
splash water onto the heater, and never
use a solvent like gasoline, isoamyl acetate,
toluene, etc. to clean the heater.
3
Electric Fan Heater User's Manual (REM-300A-120-B)
Publicidad
