Technical Specification; Fuse Changes; Guarantee; Standards Compliance - Profile CR60 Manual De Instrucciones

Technical specification

Part no. CR60
1750
Voltage 230V
Frequency 50Hz
Power Consumption 200VA
Fuse 1 x T1.0 amp
(5 x 20mm)
Filter part no. 2020
Nominal dynamic 8.5 lpm
flow*
Weight 2.8kg
Compressor wobble 'Ultra-clean'
Dimensions:
Height 150mm
Width 155mm
Depth 225mm
Type Class II
BF
Rating Continuous
~
Stands for Alternating Current.
*Flow through Sidestream Nebulizer Jet.
Inlet Filter-Porous Polyethylene.
0120
8

Fuse Changes

The mains fuse located in the electrical inlet
connection, are T1.0 amp.
~
* To gain access to the mains fuse, insert a
small screwdriver into the slot on the
electrical inlet connection and twist to
release the door (see diagram).
The mains plug is fitted with a 3 amp fuse.

Guarantee

The CR60 is guaranteed against defects in
materials and workmanship for one year
from the date of purchase.
Only Profile Respiratory Systems approved
parts may be used to service this equipment.
Use of non-approved parts may invalidate
the Test Certificate issued for the CR60
nebulizer compressor.
This guarantee does not affect your statutory
rights.
Standard compliance
The CR60 high flow is manufactured to
the requirements of IEC601-1 for class II
Type BF equipment. The CR60 meets
EN 60601-1-2 :1993 Medical Electrical
Equipment, General Reqiurements for Safety:
Electromagnetic Compatibility.
Transport & storage at:–
An ambient temperature of +10˚C to +40˚C.
A relative humidity range of 30% to 75%.
An atmospheric pressure range of 700hPa
to 1060hPa.
Symbols
Attention, consult accompaning
documents.