Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
ceiling using the appropriate screws.
Make sure it is well fixed.
• Warning: the screws supplied are
designed to be used on wooden
beams and concrete ceilings. Keep
the previously loosened screws of the
bracket in the same position, so that the
fan body can be mounted later. (Pic. 3)
• Step 04: We will now proceed to connect
the cables coming out from the ceiling
to the motor leads coming from the
fan reciver. To make the process easier
you may want to get somebody´s help
to hold the fan lifted while you do the
pertinent electrical connections, since
the receiver is connected to the fan
body. Use the caps provided to connect
the wires coming out of the ceiling to
the wires coming out of the receiver.
Make the splices of the two phase wires
(L) and the two neutral wires (N) and
seal them with the caps provided, as
shown in the picture (fig.4). See picture
05 on page 7.
• If the cables coming from the motor are
not connected to the receiver, proceed
by connecting the set of cables coming
from the motor body to the cable inlet of
the receiver. See picture 05 on page 7.
• Step
05:
Once
connections have been finished, we will
put the fan on the ceiling bracket. To do
this, alight the slots on the top part of
the fan with the screws in the ceiling
bracket which you have previously
loosened in the first step, and insert
them in the same position they were
originally (pic. 5)
• Step 06: Then, turn the fan body until
the screws are fitted in the correct
position. Then tighten the screws. (pic.
6).
Once you have finished the installation
make sure the product works correctly. Pay
special attention to any strange oscillation
or malfunction in any of the fan parts.
28
all
the
electrical
Remote control connection:
See picture 05 on page 7.
L : AC IN 220-240V
N : AC IN 220-240V
USING THE APPLIANCE
This device is very easy to use and does
not require much knowledge. However, we
advise you to familiarize yourself with the
instructions below.
The fan has 6 power levels that can be
selected through the remote control. It also
has a timer of up to 2 hours.
Remote control:
See picture 07 on page 8.
The device incorporates a remote control,
for a more comfortable and efficient use.
In order for the remote control to work, it
must always be aimed at the fan.
Before you start using it, please take a few
minutes to familiarize yourself with the
functions:
6.
Button : Press this button to
switch off the fan and light.
7.
Button : Press this button to
activate and deactivate the grill
rotation function.
8.
Button: press this button to
change the rotation direction of the
blades. When the fan rotates sending
the air upwards you are using it in
its winter function. When the fan
rotates sending the air downwards
you will be using it in its summer
function.
9.
Button: Press the button to turn
the fan on and off.
10. Buttons 1 to 6: Press any of these
buttons to set the fan speed, being 1
the lowest speed and 6 the highest.
11.
Button:Press this button to turn
on and off the light. If you want to
change the light colour, press it until
the wanted colour is set.
12.
Button:
the brightness of the light. It will
press
to
increase
Publicidad
