Publicidad
Idiomas disponibles
Idiomas disponibles
Safety instructions
WARNING!
Read all safety notices and instructions.
Failure to comply with the safety notices and
instructions may result in electric shock, fire
and/or serious injuries . Keep all safety
notices and instructions in a safe place for
future reference.
Safety instructions for vacuum lifter
Do not deliberately try to rip the load off
with extreme force. There is a risk of the
load crushing feet and hands and
damaging the object and tool.
Do not lift objects weighing more than
130 kg (287 lbs). There is a risk the weight
can fall off.
Risk of load crushing feet and hands and
damaging the object and tool. Do not
shake the tool while lifting, moving and
placing objects. Do not swing or shake the
load while lifting, moving and placing
objects. Do not use the tool when the seal
is worn out. Lift and carry the load with
uniform speed without sudden sharp and
strong movements.
Do not use the tool while the battery is low.
There is a risk of injury and damage to the
materials being lifted.
If the sealing force begins to noticeably
decrease while the battery is fully charged,
check the rubber foam seal for wear and
tear or damage. Do not attempt to lift
anything with the tool until you have
replaced the seal.
Use caution when lifting large thin flexible
sheets, like drywall, cardboard, plastic,
plywood, thin sheet metal etc. Thin sheets
bend and flex and can unexpectedly
change curvature above their limit and
detach.
Do not attach the tool to surfaces with
visible puddles ofwater. Internal
components are not waterproof. If water is
sucked into the air ducts it can cause
permanent damage to the tool. The tool is
not waterproof and therefore extreme
caution should be taken when using it in
the rain or wet conditions.
Never let the tool fall to the floor. If it falls
down inadvertently, inspect the device and
the sealing lips for damage.
16
Do not place heavy objects on topof the
tool.
Do not place the digital display indirect
sunlight or near strong heat sources for
prolonged periods. Extreme heat may
damage the display and it may become
unreadable. A damaged display does not
necessarily impact the functionality of the
tool.
To avoid overheating, do not cover the
tool.
Ensure the switch is in the off-position
before transporting the tool and when in
storage. Be mindful that the tool is not
switched on accidently.
Use only original batteries with the
voltage indicated on the type plate of
your power tool. The use of other
batteries, e.g. imitations, reconditioned
batteries or other makes, increases the
risk of injury and material damage by
exploding batteries.
WARNING!
If the safety precautions are not heeded, the
load could fall without warning. The power
tool generates a strong vacuum.
Failure of this kind can occur very suddenly
and without any tangible indication or
prewarning if the seal is damaged or the
maximum permissible weight is exceeded
or another factor occurs resulting in
spontaneous loss of the vacuum.
There will be no indication of the load
detaching itself and there will be no means
of stopping or catching it. This represents a
high risk, particularly with heavy loads. All
possible safety precautions should
therefore be taken in full.
NOTE
Due to the high negative pressure
generated by the power tool, it is strongly
recommended not to attach the power tool
to glass less than 6 mm thick. Glass thinner
than 6 mm can break.
VLP 18
Publicidad
