Publicidad
Idiomas disponibles
Idiomas disponibles
Lifting diagonally
NOTE
Use this essential lifting technique for small
items by positioning yourself over the load
and lifting with legs apart.
Get as close to the item as possible.
Stand with legs apart, one foot in front of
the item and one foot to the side of the item
to maintain a good balance.
Keep your back straight and press your
buttocks out. Bend with your legs and hips
down to the item.
Bring the item as close to yourself as
possible.
Place your hand (on the same side as the
foot that you placed in front of the item) on
the side of the item that is furthest away
from you.
Secure the load with your free hand while
the load is lifted and the tool is held with
one hand.
Before lifting, tense your core muscles,
look ahead, keep your back stiff and
straight.
NOTE
You should not hold your breath when
lifting. Do not bend and turn at the waist.
Always grip with the whole hand. Do not
impair your vision while carrying. Do not
yank the load or lift it quickly. Do not trap
your fingers or toes.
Lift the load slowly, following with head and
shoulders.
Keep the load close to your body.
Stretch your legs with back straight and
exhale when lifting.
Turn your feet to prevent twisting.
24
Teaching-in mode / recalibration mode
In the event of problems with the digital
display, please carry out the following steps
to reset the digital display.
Place the tool on a non-porous surface,
e.g. a polished tile.
Switch on the device.
Press the selector button for the unit of
measurement (12) and hold for 10 seconds.
As soon as the pump starts, release the
selector button for the unit of
measurement (12). The calibration routine
takes 10-15 seconds.
When the pump switches off, the
calibration routine is complete.
Switch the tool off and on again.
The tool is now calibrated and the values on
the digital display should be correct.
NOTE
The tool will show incorrect values on the
digital display if it is not calibrated on a non-
porous surface such as a tile or piece of
glass. If this is the case, the calibration
routine must be repeated on a non-porous
material. Do NOT perform this routine on
glass that is thinner than 6 mm as the glass
can break.
Maintenance and care
WARNING!
Before working on the tool, remove the
battery.
Cleaning
WARNING!
Do not use water or liquid detergents.
Clean the tool and foam seal at regular
intervals. The frequency of cleaning is
dependent on the material and duration of
use.
Check the foam seal for damage at regular
intervals.
Clean the air filter at regular intervals using
compressed air.
VLP 18
Publicidad
