Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING / REMOVING/CLEANING THE DUST SCREEN
Using the dust screen will increase the performance and extend the life of the tool.
CAUTION
Do not use tool without dust screen installed.
1. To use a screwdriver to loosen the screw and remove the dust screen from the tool.
2. To clean the dust screen, tap against a hard surface or blow clean with compressed
air.
WARNING
operation where the fastener may contact hidden wiring. Fasteners contacting a "live" wire may make
exposed metal parts of the power tool "live" and could give the operator an electric shock.
STARTING, STOPPING AND CONTROLLING SPEED
Generally, lower speeds are recommended for tight work areas and higher speeds are
ideal for large surface areas. Using the speed control dial to set the maximum speed for
the application
1. Set the speed control dial to the desired maximum speed.(800-2200 rpm)
2. Pull the trigger
3. Increase or decrease pressure on the trigger to vary the speed, up to the speed set
on the dial.
4. Use the trigger lock (push it from right side to left side) to LOCK ON the tool for
continuous use, if desired
1English1
OPERATION
Hold the power tool by insulated gripping surfaces, when performing an
Fig. 5
Fig. 6
English
-10
Publicidad
