Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
Note: Before mounting, decide where you want to mount the solar cell
and the main unit
solar cell
and the main unit
4
Mounting the main unit
Make sure that you will not drill into electrical, gas or water lines inside
the wall. Use a power drill to drill holes into brick walls. Always observe
all safety instructions in the power drill manual. Death or injury due to
electric shock may otherwise result.
Please remember when selecting the location for mounting the main
unit
:
1
Note: Make sure the main unit
directly, otherwise the charging function may be affected.
1. The connection between the LED spotlight
flexible and should be able to illuminate the selected area (see Fig. D).
Note: Please be careful that the connection cable does not get jammed
when rotating the LED spotlight
2. Depending on the mounting height (ideally between 1.80 m–2.00 m)
the motion detector
detection angle of 90° horizontally and 90° vertically.
3. Be sure the motion detector
night. This can influence its functioning.
Secure the main unit
(ø 6 mm) and two of the enclosed screws
Note: The enclosed mounting material is suitable for ordinary masonry
construction. Other wall substrates may require other fastening materi-
als. Seek specialist advice when in doubt.
After mounting, check that the main unit
. Please remember the connection cable between the
1
is approx. 2.5 m long.
1
has a detection range of max. 12 m with a
3
is not illuminated by street lighting at
3
using two of the enclosed wall plugs
1
is not illuminated by sunlight
1
and the main unit is
2
(see Fig. E).
2
(4 x 30 mm) (see Fig. B).
6
is fitted securely.
1
4
7
GB/IE
27
Publicidad
