LIVARNO home 434405 2304 Guia De Inicio Rapido página 13

size socket head screws
5
the lamp base from below (Fig. A).
□ Guide the main tube
7
screws and tighten these with the hex key
8
.
Note: The connection cable
6
should face the edge of the lamp base
□ Loosen the two outer socket head set screws
for the upper LED unit
1a
outer LED strips
1a
strips out by approx. 2 cm, swivelling them
outwards and reinserting them.
□
Secure the LED strips
socket head set screws
(Fig. B).
□ Guide the fully assembled LED unit
6
main tube and plug the connecting plug
for the upper LED unit
socket on the main tube
□ Now plug the LED unit
6
. When doing so, ensure the bores on the
6
main tube and the screw entries on the LED
1
unit are congruent.
□
Insert both socket head screws
bores on the main tube
socke head screws
12
key .
□ Plug the LED plug-in mains adapter
properly installed mains socket.
Your light is now ready to use.
Switching the luminaire on/off
□ Switch the light on or off using the ON/OFF
2
switch on the upper end of the main tube
6
. You only need to press it with your finger
(touch switch).
Dimming the light
□ The light features a variable dimmer. Hold the
2
ON/OFF switch
will automatically dim to the max. or min.
brightness.
7
into the openings in
6
over the socket head
3
for the main tube
5
1
and arrange the two
by pulling the outer LED
1a
by tightening the
10
with the hex key
1
over the
14
into the connecting
13
(Fig. C).
1
into the main tube
11
into the
6
and tighten the
11
using the included hex
4
into a
to activate it. The light
□
After releasing the ON/OFF switch
light will remain at the selected brightness.
Note: The lamp has a memory function. It saves
the most recently selected dimming level. The
light switches on again in the dimming level
most recently selected.
.
Maintenance and cleaning
10
WARNING: ELECTRIC SHOCK Always
unplug the LED plug-in power supply
from the socket before cleaning.
WARNING: ELECTRIC SHOCK For
reasons of electrical safety, the light must
9
never be cleaned using aggressive clean-
ing agents or immersed in water.
CAUTION: HOT SURFACES – RISK OF
BURNING Let the light cool down
completely.
□
Never use solvents, petrol, etc. These can dam-
age the light.
□ Always use a dry, lint-free cloth for cleaning.
Disposal
The packaging consists of environmentally friendly
materials that you can dispose of in your local recy-
cling facilities.
Check the marking on the packaging
when sorting your waste. Packaging
materials are marked with abbreviations
(a) and numbers (b) as follows: 1–7: plastics/ 20–22:
paper and cardboard/80–98: composites.
Ask your local administrative council or
waste disposal facility about how to
dispose of the product at the end of its life.
The adjacent symbol of a crossed-out
wheeled garbage can indicates that this
device is subject to Directive 2012/19/
EU. This directive states that you must not dispose of
this device with normal household waste at the end of
its service life, but must take it to specially set up
2
, the
4
GB/IE/NI/CY/MT 9