Publicidad
Idiomas disponibles
Idiomas disponibles
5.10 Timer function
With the timer function, you can set a time
after which the fan automatically switches
off. You can set a time between 1 and
6 hours in 1-hour increments.
•
With the device switched on, press the
Timer 23 button repeatedly. 1 hour
is added each time the button is
pressed. The lit LEDs of the display 16
show the set time. Add up the times of
the lit LEDs to get the set time:
- 1 H: 1 hour
- 2 H: 2 hours
- 3 H: 3 hours
Example:
The following LEDs are lit:
1 H + 3 H.
This means that the timer is set to:
1 + 3 hours = 4 hours.
•
While the timer is running, the remain-
ing time is displayed.
•
After the set time has elapsed, the de-
vice switches off.
6. Cleaning and care
DANGER! Risk of electric
shock!
Always disconnect the power supply
unit 7 before cleaning.
Never immerse the device 10 in water.
Do not let water or cleaning agent run
into the device 10.
WARNING! Risk of material dam-
age!
Do not clean using sharp objects or
abrasive cleaning agents.
NOTES:
•
To ensure that your device 10 always
functions hygienically, clean the water
tank 13 regularly (after 72 hours at the
26 GB
latest) and replace the filter in a timely
manner. Also ensure that all accessories
are dry and clean when the device 10
is not in use.
•
After 72 hours at the latest, the de-
vice 10 reminds you to clean the water
tank 13 by the LED 4 flashing red and
sounding an acoustic signal.
6.1
Cleaning the water
tank
•
After each use, rinse the water
tank 13 thoroughly with tap water.
•
After 3 days (72 hours) at the
latest, rinse the water tank 13 with
warm vinegar water. Then rinse thor-
oughly with clear tap water.
•
Dry the outside of the water tank 13.
•
If you do not immediately use the de-
vice 10 again, allow the water
tank 13 and the filter to dry completely.
6.2
Replacing the filter
Every 6 months or so you should replace the
filter with a new one. You can reorder new
filters (see "Ordering accessories" on
page 28).
• Check the filter regularly for damage,
dirt or odours. A damaged, dirty or un-
pleasant smelling filter must be re-
placed.
NOTE: the misting function
does not work without the filter inserted.
1. Pull the water tank 13 out of the de-
vice 10.
2. Remove the lid 15 from the water
tank 13.
Mist 21
Publicidad
