Publicidad
Idiomas disponibles
Idiomas disponibles
COMPONENTS
1
LCD display: display for torque, working mode and unit of measurement.
2
Buzzer: sounds when the torque is reached.
3
Button C: power on / reset
4
Button U/S:
Press the button for one second, the display shows "Unit Setting".
Press the button for longer than a second, the display shows "Mode", "Data Storage", "Data
Clear", "Data Output".
5
Button M: To switch between the 9 frequently used torque values in the memory.
6
Button Up & Down: Setting the torque value.
7
Battery compartment: Battery compartment and cover on the back.
8
LED light bar: The LEDs are also visible from the side and show a progressive course when
tightening until the previously set torque value is reached via 1 red and 5 green LEDs.
9
Display area: shows the current working mode and the unit of measurement.
BATTERIES SAFETY INFORMATIONS
•
Do not mix old and new batteries with this torque wrench.
•
Do not mix alkaline with carbon zinc or rechargeable lithium-ion (Li-ion) batteries.
•
Do not install batteries backwards.
•
Do not throw batteries into fire. Batteries can explode or leak causing personal injury.
•
Remove batteries when storing the torque wrench for a long period. Batteries should be stored
at room temperature.
INSERTING / REPLACING BATTERIES
Note: If the batteries are worned, a battery symbol appears in the display and the batteries should
be replaced as soon as possible. After the symbol appears, the electronics switch off after a certain
time.
1. The supplied Phillips screwdriver is used to remove the battery compartment cover.
2. Loosen the four Phillips screws to remove the battery compartment cover (7).
3. Insert two new AAA batteries into the battery compartment, making sure that the batteries are
inserted correctly (polarity).
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
