fanttik NEX L1 Pro Instrucciones página 11

Maintenance and Service
Maintenance and Cleaning
-
Before any work on the power tool (e.g. maintenance, tool change, etc. ) as well as during transport and storage, set the
rotational direction switch to the middle position. There is a risk of injury if the power tool is started up accidentally.
-
Keep the power tool clean to ensure good, safe operation.
Transport
The contained lithium-ion batteries are subject to the Dangerous Goods Legislation requirements. The batteries are suitable
for road-transport by the user without further restrictions.
When shipping by third parties (e.g. :by air transport or forwarding agency) ,special requirements on packaging and labelling
must be observed. For preparation of the item being shipped, consulting an expert for hazardous material is required.
Disposal
Power tools, rechargeable batteries, accessories and packaging should be sorted for environmental-friendly recycling.
Do not dispose of power tools and batteries/rechargeable batteries into household waste!
Battery packs/batteries:
Li-ion:
Please observe the notes in the section on transport .
●
Integrated batteries may only be removed for disposal by qualified personnel. Opening the housing shell can destroy the power tool.
Before you can remove the battery from the power tool, you will need to use the power tool until the battery is completely
discharged. Unscrew the screws on the housing and remove the housing shell in order to remove the battery. To prevent a
short circuit, disconnect the connectors on the battery one at a time and then isolate the poles. Even when fully discharged,
the battery still contains a residual capacity which can be released in case of a short circuit.
08
English –