Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION - General information
The below description goes with the image on page 2.
1. The LCD display indicates that:
a. the battery is full or almost empty
b. a negative value is measured
c. the tare function is used
d. the normal weighing function is used
e. the volume is measured in fluid ounces
f. the volume is measured in milliliters
g. weight is measured in pounds and ounces
h. the weight is measured in ounces
i. the weight is measured in grams
2. Unit button (g / oz / fl'oz / ml / lb'oz)
3. Weighing platform
4. On/Off button and Tare button for weighing function
5. Battery compartment (bottom)
OPERATION - BEFORE YOU START (SEE FIGURES 1 & 2)
For your convenience, a battery (type CR2032) is already installed in this device at the factory.
1. Open the battery compartment (figure 1, no. 5) on the bottom of the device by pulling the tab up (figure 2).
2. Remove the sticker from the battery before using the device.
3. Close the battery compartment.
OPERATION - WEIGHING (SEE FIGURE 1 & 2)
1.
Place the scale on a solid and flat surface.
2.
You can optionally place a bowl or scale on the weighing platform (figure 1, no. 3) to place the goods
to be weighed. Always do this before switching on the device.
3.
Switch on the device by pressing the On/Off button (4). Wait until the number "0" appears in the display.
4.
Select your preferred measurement system by pressing the unit button (2). In the display (1) you will
see g (grams), oz (ounces), fl'oz (fluid ounces), ml (milliliters) or lb'oz (pounds and ounces) flashing
alternately.
5.
Place the goods to be weighed on the weighing platform (or in the bowl or dish). The number "0"
appears in the display
6.
You can switch the device off again by pressing the On/Off button for approximately 3 seconds.
NB:
•
You can weigh up to 5 kg.
•
The device switches itself off when it is not used for approximately 90 seconds. Your system choice is
remembered by the device after switching off.
OPERATION - WEIGHING FUNCTION (SEE FIGURE 1 & 2)
If you want to weigh several items one after the other without having to empty the scale each time, you can
use the weighing function:
1. Place the scale on a solid and flat surface.
2. You can place a bowl or scale on the weighing platform to place the goods to be weighed. Always do
this before switching on the device.
3. Switch on the device by pressing the On/Off button. The number "0" appears in the display.
4. Place the first items to be weighed on the weighing platform (or in the bowl or dish). The display now
shows the weight.
5. Now press the Tare button (figure 1, no. 4) to reset the value in the display to zero. The number "0"
appears in the display.
6. Now repeat steps 4 and 5 until you have weighed all the goods.
7. After you have removed everything from the weighing platform, the display will show a negative value.
The weight shown on the display is then the total weight of all goods.
8. You can switch the device off again by pressing the On/Off button for approximately 3 seconds.
13
13
EN
EN
Publicidad
