Publicidad
Normas y homologaciones
Nota
Homologaciones indicadas en la placa de características
La sinopsis siguiente proporciona información sobre las posibles homologaciones.
Para el equipo solo rigen las homologaciones impresas en la placa de características.
11.1
Certificados y homologaciones
El sistema de gestión de calidad de todo el proceso de producción (desarrollo, fabricación y
venta) cumple los requisitos de la norma ISO 9001.
Para certificarlo, contamos con la confirmación de la DQS (Deutsche Gesellschaft zur
Zertifizierung von Qualitätsmanagementsystemen mbH, asociación alemana para la
certificación de sistemas de gestión de calidad).
Si el dispositivo se suministra con software instalado, deben observarse los acuerdos de
licencia correspondientes.
El equipo tiene las siguientes homologaciones:
• Underwriters Laboratories (UL) según la norma UL 62368-1 Third Edition (PROG.CNTLR.)
• Canadian National Standard CAN/CSA C22.2 No. 62368-1-14 Third Edition
FCC USA
Federal
Communications
Commission
Radio Frequency
Interference
Statement
Shielded Cables
Modifications
Conditions of
Operations
SIMATIC IPC MD-57A
Instrucciones de servicio, 09/2023, A5E52775318-AA
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Shielded cables must be used with this equipment to maintain compliance with
FCC regulations.
Changes or modifications not expressly approved by the manufacturer could void
the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules and Industry Canada license-
exempt RSS standard(s). Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired
operation.
11
89
Publicidad
