Descargar Imprimir esta página

Omega 7142 Manual De Instrucciones página 50

Ocultar thumbs Ver también para 7142:

Publicidad

1
a
b b
2
Creación de monogramas y recamado
con aro de bordar*
Baje los dientes del transportador (NOTA: El largo no puede
controlarse con el disco).
- Ajuste la máquina según se ilustra.
- Retire el prensatelas y su soporte.
- Deslice el control del transportador de dientes al lado
derecho para bajar los dientes. (1)
- Baje la palanca del prensatelas antes de comenzar a coser.
- Ajuste el ancho de acuerdo con el tamaño de las letras del
monograma o dibujo.
Preparación para la creación del monograma bordado*
- Traza las letras o el dibujo deseado en el lado derecho de
la tela.
- Extienda la tela dentro del bastidor con la mayor firmeza
posible.
- Coloque la tela debajo de la aguja: Cerciórese de que la
barra del pié prénsatela esté en la posición mas baja.
- Gire el volante hacia usted para elevar el hilo inferior a
través de la tela. Proceda a coser unas pocas puntadas en
el punto inicial.
- Sujete el aro con los dedos pulgar e índice de ambas
manos.
* Coordine la velocidad de cosido y el movimiento del aro.
B
- Set the machine as illustrated.
- Remove the presser foot and the presser foot holder.
- Move the drop feed control to right side to lower the feed
- Lower presser foot lever before starting to sew.
- Adjust the stitch width according to the size of lettering or
Preparation for Monogramming and Embroidering*
- Draw the desired lettering or design on the right side of the
a
- Stretch the fabric between embroidery hoop as firmly as
b
- Place the fabric under the needle. Make sure the presser
- Turn the balance wheel towards you to bring up the lower
- Hold the hoop with thumb and forefingers of both hands
* Embroidery hoop not included with machine.
- Régler la machine tel que démontré ci-dessus.
- Enlever le pied-de-biche et le portepied.
- Abaisser le transporteur. (1)
- Abaisser le levier du pied presseur avant de commencer à
- Ajuster la largeur du zigzag selon la grandeur du
Préparation pour le monogramme et la broderie à main
libre*
- Dessiner le monogramme ou le motif sur l'endroit du tissu.
- Placer le tissu dans un cerceau à broder et le tendre le plus
- Placer le tissu sous l'aiguille. Assurez-vous que la barre du
- En tournant le volant vers vous, faire passer le fil de la
- Retenir le cerceau avec le pouce et l'index des deux mains,
* Le cerceau à broder n'est pas inclus avec les accessoires
43
https://manual-hub.com/
Monogramming and embroidering
with embroidery hoop*
dogs. (1)
design.
fabric.
possible.
foot bar is down in its lowest position.
thread through the fabric. Sew a few securing stitches at
the starting point.
while pressing the material with the middle and third fingers
and supporting the outside of hoop with smaller finger.
Monogramme et broderie à main
libre*
coudre.
monogramme ou du motif à broder.
fermement possible.
pied presseur est à sa position la plus basse.
canette à travers le tissu et ressortir sur l'endroit du tissu.
Coudre quelques points d'arrêt au point de départ.
tout en pressant le tissu avec les doigts du milieu alors que
l'auriculaire soutient le bord extérieur du cerceau.
de la machine.

Publicidad

loading