HOTO Laser Level 3 360 Manual Del Usuario página 12

Remote control use
The remote control needs to be used when the main unit is on
1.If the remote control cannot control the main unit, please
complete the pairing bet ween the remote control and the main unit.
Pairing method: Press and hold the"top laser control button"on the
product and the remote control at the same time for 2 seconds under the
power-on state to re-connect with the main unit.
2. The "Front laser control button", "Side laser control button" and "Top laser
control buttons" on the remote control are the same as the corresponding
buttons on the main unit.
3. The "Mode button" on the remote control can be short pressed to switch
between full bright mode and pulse mode, while it can not be long pressed to
control power on/off.
Note: Push the left slider to the right and then pull it out to remove the
battery compartment. Please use the CR2025 battery.
8