Crivit 373655 2104 Guía Rápida página 10

Preventing damage to the product!
• Avoid water, oil, potholes and very rough
surfaces.
Assembly
The product is supplied folded up in transport
condition. Proceed as follows to get it ready for
riding:
Unfolding (Fig. A)
1. Pull the safety lever (1) upwards and hold it.
2. Pull the lever (2) upwards, then release the
safety lever and fold the steering column (3)
forwards until it locks into place.
Mounting the grips (Fig. B)
1. Remove the grips (4) from the brackets (5).
2. Lift the cover flap (6).
3. Press the locking knobs (7) down on the grips
and push the grips on both sides into the
T-tube (8) of the steering column. The locking
knobs must snap audibly into place into the
holes (9) provided.
4. Press the cover flap down over the locking
knobs.
Note: Tighten the retaining screws on
the cover flap regularly.
Adjusting the height of the steering
column (Fig. C)
The steering column can be adjusted to four
different heights. The product may only be used
if the locking knob is locked in place into one of
the four holes provided and the steering column
is then secured with the quick release fastener!
1. Loosen the quick release (10) on the steering
column (3).
2. Pull the steering column upwards, until the
locking knob (11) locks into place in one of
the four holes (12).
3. Secure the steering column by locking the
quick release.
Note: If the quick release does not fit snugly on
the steering column when tightening, tighten the
knurled screw firmly with the enclosed Allen key.
Make sure that the quick release fastener is
secured before tightening.
10 GB/IE
Steering head bearing (Fig. D)
On product delivery the steering head bear-
ing (13) is preset. If the handlebar has too much
play after some time or becomes too tight, have
the steering head bearing adjusted by a speciali-
ty retailer or a bicycle shop.
Brake
Adjusting the brake
ATTENTION!
The brake must be adjusted so the back
wheel moves freely when the brake
lever is released and locks when engag-
ing the brake lever.
Turn the adjusting and locking nut (21) to the left
to reduce the braking force, turn the adjusting
and locking nut to the right to increase the brak-
ing force (Fig. E).
Readying the product
for transport
1. Release the quick-release lever (10) on
the steering post (3) and push in the locking
button (11) (Fig. C).
2. Push the steering post (3) in all the way and
tighten the quick-release lever (10) (Fig. C).
3. Lift the cover flap (6) (Fig. B).
4. Push in the locking buttons (7) on the handles
and pull the handles (4) out of the T-bar (8)
(Fig. B).
5. Secure the handles in the holders (5) (Fig. B).
6. Close the cover flap again.
7. Pull the clamping lever (1) up and hold in
place (Fig. F). Pull the lever (2) up, then
release the clamping lever (1).
8. Move the steering post (3) toward the deck
(14) until it locks into place (Fig. F).
Use
Riding, braking, parking (Fig. G)
• Fold in the kickstand (16) before using the
product.
• Place one leg on the deck (14) and put into
motion by evenly pushing off with the oth-
er leg.