ProMed PBM-4.2 Instrucciones De Empleo página 28

I
NBETRIEBNAHME
Troubleshooting
DE
Problem
No electricity
EN
FR
The device does
not pump
IT
Error and/or
ES
inter ruption of
the measurement
NL
The arm cuff
RU
does not fill
with air
PL
SE
If the fault cannot be rectified, contact the manufacturer before you try to repair the
device yourself.
AR
Errors seem to occur
during inflation
Abnormal blood pres-
sure
Batteries flat
Possible cause to be
checked
Check the batteries
Check that the batteries
have been correctly in-
serted (polarity)
Check whether the tube
connecting piece is correct-
ly inserted in the device
Check whether the tube
connecting piece is intact
Check whether the arm is
laying still and relaxed
Was there talking during
the measurement?
Check that the arm cuff is
on properly
Check whether the arm cuff
or tube has a hole
Put the arm cuff on correctly.
Check whether the tube connecting
piece is correctly inserted in the device.
Check that there are no holes in
the tube or the cuff and repeat the
measurement
Relax for at least 30 minutes, then re-
measure. If you get the same results, you
must see your doctor immediately.
Replace the old batteries with new ones.
Solution
Replace with new ones
Insert batteries correctly
Insert the tube connecting piece gently
into the connection
Replace with a new tube connecting
piece
Ensure a calm and relaxed position
Do not speak during the measurement
Fasten the arm cuff correctly
Replace the arm cuff with a new one
28