AENO EK7S Guia De Inicio Rapido página 8

Indicator Status
Off
Functions of buttons
Button Action
"Start/Stop" button
Press once
Tap and hold
Temperature selection and maintenance button
Press once
Preparing for the First Use
Before using the device for the first time, clean it by doing the following:
1. Open the packaging and remove the device. Remove any packaging
materials.
2. Place the stand on a flat, stable surface.
3. Open the lid of the kettle and fill with water up to the "MAX" mark.
4. Close the lid tightly and place the kettle on the stand.
5. Insert the plug into the socket.
6. Tap button: after a beep, the water starts heating.
7. Wait until the water boils and three beeps sound.
8. Remove the kettle from the stand and carefully drain the water.
ATTENTION! Do not drink water obtained after the first two boilings.
9. Allow the device to cool down and repeat steps 3–8.
10. After the device has cooled down completely, wipe the exterior and interior
surfaces with a dry cloth.
8
Description
Temperature maintenance or pairing is
completed/interrupted or the device is
turned off
Description
Starts boiling water; interrupts boiling, heating or
maintaining the temperature
Activating pairing mode
Selection of water heating temperature
aeno.com/documents